This is a Chevrolet 350 Small Block V8 5.7L engine for sale, fairly used, checked in our shop and ready to ship to you anywhere in the world. It’s the same 350 cubic inch Chevy that went into Camaros, Corvettes, Chevelles, Novas, C10 pickups, Suburbans and vans for more than thirty years. If your old 350 is knocking, smoking or seized, this is a straight swap.
Prices run from $2,200 for a long block up to $4,500 for a complete engine with intake, carb or injection, distributor and accessories. Where your engine lands in that range depends on the year, the heads and what’s bolted to it. Tell us your car and we’ll quote the right Chevrolet 350 Small Block V8 5.7L with shipping to your door.

Table of Contents
What You Get With the Chevrolet 350 Small Block V8 5.7L
We sell it two ways:
- Long block, from $2,200: block, crank, rods, pistons, cam, heads, valvetrain, timing set, oil pan, valve covers and timing cover. You move your own intake, carb or throttle body, distributor and accessories over.
- Complete engine, up to $4,500: the long block plus intake manifold, carburetor or fuel injection, distributor and exhaust manifolds, and where we have them, the water pump, alternator and brackets.
Either way you get photos and a short video of the engine turning over before you pay, plus the casting number and the stamp on the block. No guessing about what’s coming.
Chevrolet 350 Small Block V8 5.7L Specifications
| Engine family | Chevrolet small block, first generation |
| Displacement | 350 cu in (5.7 L, 5,733 cc) |
| Layout | 90 degree V8, overhead valves, 16 valves |
| Bore x stroke | 4.00 x 3.48 in (101.6 x 88.4 mm) |
| Block and heads | Cast iron block, cast iron heads (aluminum on some performance versions) |
| Firing order | 1-8-4-3-6-5-7-2 |
| Power | About 145 to 370 hp depending on year and version |
| Torque | About 250 to 380 lb-ft |
| Compression | About 8.0:1 to 11.0:1 |
| Fuel system | 4 barrel carburetor, TBI, TPI or Vortec multiport injection |
| Oil capacity | 5 US quarts with filter |
| Dressed weight | Roughly 550 to 600 lb |
| Years built | 1967 to the early 2000s, crate versions still made |
Worth knowing: the 1990s LT1 and the later LS1 and LS6 are also 5.7 litres, but they are different engines. The Chevrolet 350 Small Block V8 5.7L on this page is the original first generation design, the one with the distributor at the back and the bolt pattern every hot rodder knows. If you need the newer LS type, look at our used LS engines instead.
Cars and Trucks That Used the 350
Chevy put this engine in almost everything it built for three decades. These are the ones people ask us about most:
- Chevrolet Camaro, 1967 to 1981, and the 350 TPI IROC-Z and Z28 from 1987 to 1992
- Chevrolet Corvette, 1969 to 1991 (L46, LT-1, L48, L82, L83 and L98 versions)
- Chevrolet Chevelle and Malibu, 1969 to 1977
- Chevrolet Nova, 1968 to 1979
- Chevrolet Monte Carlo, 1970s models
- Chevrolet Impala and Caprice, late 1960s through the 1980s, including the 9C1 police cars
- Chevrolet El Camino
- Chevrolet C10, C20, K10 and K20 pickups, and the GMT400 Silverado and Sierra up to about 2000
- Chevrolet Suburban, Blazer K5 and the 1995 to 1999 Tahoe
- Chevrolet Express and GMC Savana vans up to 2002
- Some Pontiac Firebird and Trans Am years, plus Checker cars
Not sure what’s in yours? Send the VIN or a photo of the stamp on the small pad just in front of the passenger side cylinder head and we’ll tell you.
Why People Still Want the 350
Parts are everywhere and they’re cheap. Every machine shop knows the engine. It fits more cars than any other V8, bolts up to a Turbo 350, 700R4 or 4L60E gearbox, and takes a beating. Restorers want one to keep a car looking original. Builders like it because a mild cam, decent heads and a 4 barrel will give you 300 hp without much work. And plenty of fleet owners still run 350 powered vans and trucks because a roadside mechanic can fix them.
That’s why a Chevrolet 350 Small Block V8 5.7L is usually the first engine we point people to when they have an old Chevy with a dead motor and a tight budget.
How We Check Every Chevrolet 350 Small Block V8 5.7L
- Compression test on all eight cylinders
- Drain the oil and look for metal, water or fuel
- Check the coolant for oil
- Turn it by hand and listen for knocks or tight spots
- Look for cracks near the freeze plugs and between head bolts
- Confirm casting numbers and the engine stamp
- Photograph and film it before it’s packed
If it fails any of that, it doesn’t ship.
Common 350 Problems to Know About
These engines are tough, but after decades of use a few things come up again and again on any Chevrolet 350 Small Block V8 5.7L:
- Worn cam lobes. Flat tappet cams don’t like modern low zinc oil. Run an oil with ZDDP or add a zinc additive.
- Rear main seal leaks. Engines up to 1985 use a two piece seal, 1986 and later a one piece. Both can weep with age.
- Intake gasket leaks on Vortec truck engines, sometimes letting coolant into the oil.
- Timing chain stretch on high mileage engines, which makes the timing wander.
- Cracked heads after overheating, mostly on the late Vortec heads.
We look for all of these before an engine goes on the list.
Long Block or Complete Engine?
If the intake, carb or injection and distributor on your old engine still work, the long block saves you money. If the car has been sitting for years, or you’re swapping into something that never had a 350, get the complete engine and save yourself the parts hunt. Either way it’s the same Chevrolet 350 Small Block V8 5.7L underneath.
One catch: carbureted and fuel injected engines use different intakes, and 1996 and later Vortec heads need a Vortec style intake. Tell us what you run now so we send the right setup.
Chevrolet 350 Small Block V8 5.7L Price Range
| Long block | From $2,200 |
| Complete engine | Up to $4,500 |
Low mileage engines, factory performance versions like the L82 or LT-1, and engines with aluminum heads sit at the top of the range. Shipping isn’t included because it depends on your country and on sea or air freight. You get the full figure, engine and freight, before you pay a cent.
Worldwide Shipping and Payment
We ship the Chevrolet 350 Small Block V8 5.7L to most countries. The oil and coolant are drained, the openings capped, and the engine is bolted to a pallet and wrapped. Sea freight is the cheapest way to move an engine this size. You get tracking and the customs papers. Payment is by bank transfer, with an invoice and order confirmation by email.
Before you order, read our shipping policy, billing terms and refund and returns policy.
Fitting Tips
- Prime the oil system before the first start. Spin the pump with a priming tool until oil shows at the rockers.
- Fit a new water pump, thermostat and hoses while the engine is out.
- Check the flexplate or flywheel. Engines with the one piece rear seal (1986 on) need the matching flexplate.
- Set the timing with a light and check for vacuum leaks once it’s warm.
- Re-torque the exhaust manifold bolts after the first few heat cycles.
Carb, TBI, TPI or Vortec: Which 350 Do You Have?
Over the years Chevy fed the 350 four different ways, and the top end you need depends on which one your car or truck came with.
- Carbureted, 1967 to the late 1980s: a Rochester Quadrajet or Holley 4 barrel on an iron or aluminum intake. Simple, easy to tune, and what most classic cars use.
- TBI, 1987 to 1995 trucks and vans: throttle body injection that looks like a carb with two injectors on top. Common in C/K pickups, Suburbans and Blazers.
- TPI, 1985 to 1992: tuned port injection with long runners across the top, used on the L98 Corvette, the IROC-Z and the Firebird Formula and Trans Am.
- Vortec, 1996 to 2002: the L31, with better breathing heads and multiport injection, used in the Silverado, Tahoe, Suburban and Express.
The bottom end is close to the same on all of them, so any Chevrolet 350 Small Block V8 5.7L long block can be dressed to suit. The heads and intake have to match each other though, and on an injected truck the wiring and computer have to match too. Not sure which you have? A photo of the top of your engine is enough for us to tell.
Using a 350 in a Swap or Restomod
A lot of our 350s never go back into a Chevy. People drop them into old Fords, Jeeps, Land Cruisers, kit cars, hot rods and boats. It’s compact for a V8, not too heavy, and there are mounts and adapter plates for almost anything.
Sort these out before a swap:
- Engine mounts and a crossmember to suit
- A gearbox: Turbo 350, 700R4, 4L60E or a manual with the right bellhousing
- Headers or manifolds that clear the steering and chassis
- A radiator big enough for a V8
- The fuel pump. Carbureted engines use a mechanical pump on the block. Injected engines need an electric pump at the right pressure.
Tell us what it’s going into and we’ll say whether a carbureted or injected Chevrolet 350 Small Block V8 5.7L makes more sense. For most swaps the carbureted one is easier, because there’s no computer to wire in.
Who Buys This Engine From Us
Mostly three kinds of people. Owners of classic Chevys who want the car running again without paying for a full rebuild. Mechanics and small garages who keep a couple of engines on the shelf for customers’ trucks and vans. And builders putting a hot rod or swap car together on a budget. They all want the same thing: an engine that runs, honest photos, and a fair price with shipping that doesn’t surprise them later. That’s what we try to give.
Related Engines
Want more power or a different Chevy engine? Have a look at these:
- Chevrolet 327 Small Block V8 5.4L
- Chevrolet 454 Big Block V8 7.4L
- Chevrolet 396 Big Block V8 6.5L
- Chevrolet LS6 454 V8 7.4L
- Chevy LS3 engine
- Used transmissions
You can also read our Chevrolet small block V8 guide and used Chevy engines guide, or browse all American car engines and Chevy engines. The full family history is in the Chevrolet small-block engine article, and the car that got the first 350 is covered in the first generation Camaro article.
Frequently Asked Questions
Will a Chevrolet 350 Small Block V8 5.7L fit if my car had a 305 or 327?
In most cases, yes. The 305, 327 and 350 share engine mounts and the bellhousing pattern. Check the flexplate and exhaust.
Is this the same as an LS1 or LT1?
No. Those are later designs. This is the first generation small block.
Can I get a carbureted version for an older car?
Yes. Tell us and we’ll send it with a 4 barrel intake and carb, or as a long block.
Do you ship outside the USA?
Yes, by sea or air freight to most countries.
How do I pay?
By bank transfer, with an invoice and order confirmation by email. Call +1 (209) 733-0882 with questions.
Order Your Chevrolet 350 Small Block V8 5.7L
Send us your car’s year and model, or the VIN, and where you are. We’ll match a Chevrolet 350 Small Block V8 5.7L to it and come back with a price that includes shipping, usually the same day. More about who we are on our about page.





Reviews
There are no reviews yet.